Bootstrap Framework 3.3.6

SCAN / PROGRAMMING procedure:
The receiver’s scanning process can only be carried out when the receiving system is switched on. This is the procedure: switch on the transmitter first, then press and hold the programming button “PROG” on the receiver, and only then switch on the receiving system.
During the scan process the LED flashes at half-second intervals. If no transmitter signal is located, the LED flashes at a very high rate; this means that the procedure has failed, and must be repeated. Switch off the receiving system and re-start the entire programming procedure.
If the receiver locates a transmitter signal, the LED starts to flash at one second intervals for a period of 10 seconds. If you press the programming button again during this period, the receiver stores the current stick positions for FAIL-SAFE mode. If the programming button is not pressed during this period, the receiver maintains the servos in the last valid position until the receiver picks up the transmitter signal again.

webra40 escribió:hola, me podrias decir si ese webra sintetizado es compatible con jr/graupner ???

webra40 escribió:hola, pero ya esta probado??